Notice

Draft for review: figures are cited to primary instruments but are not yet signed off.

FineCheck UAE

Calculator

Speeding fine calculator

Enter the excess over the posted limit exactly as it appears on your notice. Nothing is deducted from it: the figure often quoted as a "tolerance" is a device-accuracy specification, not a driver's buffer, and this page explains why below the tool.

What happened

km/h

Enter the excess exactly as your notice states it. Nothing is deducted from this figure — see the note below.

Why nothing is deductedCabinet Resolution 83/2022 art. 14(1)(د)/(2)(ج) sets a maximum permissible error for the speed-measurement device (3 km/h, or 3% for speeds exceeding 100 km/h) — a metrology/device-accuracy spec, not a driver's tolerance. No instrument in the searched corpus provides for any deduction from a driver's recorded speed before the tariff applies.

Result

Fine only
  • AED 600Fine
  • Black pointsnot stated
  • Vehicle impoundnot stated
  • Annex row 39 of the federal schedule applies: a fine of AED 600.
  • Annex row 39 states no black-point figure at all. That is a blank cell in the schedule, which is not the same thing as zero points.
  • Annex row 39 states no impound period. Again a blank cell, not an impound of zero days.

Source: MR 178/2017 annex row 39 · 2023-05-02 — 2027-08-07

الجدول المرفق

The full table

The full ladder

Every rung of the schedule's speeding table, with what each one states — and what it leaves blank.

← swipe the table →

The speeding rungs of the federal schedule
Over the limitFineBlack pointsImpoundAnnex rowSeverity
0–20 km/hAED 300not statednot stated40Fine onlyGrade I
21–30 km/hAED 600not statednot stated39Fine onlyGrade I
31–40 km/hAED 700not statednot stated38Fine onlyGrade I
41–50 km/hAED 1,000not statednot stated37Fine onlyGrade I
51–60 km/hAED 1,500615 days36Fine, points and impoundGrade III
61–80 km/hAED 2,0001230 days35Fine, points and impoundGrade III
over 81 km/hAED 3,0002360 days34Top of the ladderGrade IV

Source: MR 178/2017 annex rows 34–40 · 2023-05-02 — 2027-08-07

الجدول المرفق

What the law does not say

The speed "tolerance" is a device specification, not a driver's buffer

Cabinet Resolution 83/2022 art. 14(1)(د)/(2)(ج) sets a maximum permissible error for the speed-measurement device (3 km/h, or 3% for speeds exceeding 100 km/h) — a metrology/device-accuracy spec, not a driver's tolerance. No instrument in the searched corpus provides for any deduction from a driver's recorded speed before the tariff applies.

Cabinet Resolution 83/2022 art. 14(1)(د)

اللائحة الفنية لأجهزة قياس سرعة المركبات (الرادار)

ألا تتجاوز نسبة الخطأ الأقصى المسموح به في قياس السرعة 3 كم/ساعة أو 3% للسرعات التي تتجاوز 100 كم/ ساعة

Notice

Where these figures stand

Draft for review. Every figure on this site is transcribed from a named primary instrument and carries its citation, but none has been signed off by a reviewer of record yet — and a very recent amendment may not be reflected. Where the law itself is unresolved, this site says so rather than choosing an answer. The binding amount is the one on your own notice.

Every figure carries its instrument, its article or annex row, and its effective period.